Mold appearance

Mold appearance

1. The content of the mold nameplate is complete, the characters are clear and neatly arranged.

2. The nameplate should be fixed on the mold foot near the template and the reference corner. The nameplate is fixed reliably and not easy to peel off. 3.

3. the cooling water nozzle should use plastic block insert nozzle, if the customer requires otherwise, according to the requirements.

4. The cooling water nozzle should not stick out from the surface of the mold frame. 5.

5. The cooling water nozzle should be processed with a sink hole with a diameter of 25mm, 30mm and 35mm, and the hole should be chamfered and the chamfer should be consistent.

6. cooling water nozzle should be marked in and out. 7.

7. mark English characters and numbers should be greater than 5/6, positioned at 10mm directly below the spout, the handwriting should be clear, beautiful, neat and evenly spaced.

8. mold fittings should not affect the lifting and storage of the mold. There are exposed cylinders, water nozzles, pre-set mechanism, etc. below the installation, there should be support legs to protect.

9. the installation of the support leg should be fixed on the mold frame with screws through the support leg, and the support leg which is too long can be fastened on the mold frame by turning the external thread column.

10. The size of the ejector hole of the mold should meet the requirements of the specified injection molding machine, except for small molds, which cannot be ejected with only one center.

11. The positioning ring should be fixed reliably, the diameter of the ring is 100mm or 250mm, the positioning ring is 10~20mm higher than the base plate, except if the customer requires otherwise.

12. The mold dimensions should meet the requirements of the specified injection molding machine.

13. The installation direction of the mold should be marked with arrows on the front or rear template, and the word "UP" should be written next to the arrow, the arrow and the text are yellow, and the height of the word is 50 mm.

14. The surface of the mold frame should not have pits, rust stains, extra rings, inlet and outlet vapor, oil holes, etc. and defects that affect the appearance.

15. The mold should be easy to lift and transport, and the mold parts should not be disassembled when lifting, and the lifting ring should not interfere with the water nozzle, oil cylinder, pre-reset lever, etc.